Chimney liner installers toronto

Gas liners for a furance are inserted from the top of the existing chimney and fed down the flue to the point where the furnace pipe enters the wall. This is usually located in the basement. A metal sleeve is inserted at this point to prevent contact with the cement.

The liner at the top of the chimney should be properly flashed and capped. It is important that it is not cemented at this point to allow for expansion and cleaning. Oil liners for a furnace chimney are made of stainless steel. They are inserted from the top of the existing chimney and fed down the flue to the point where the furnance pipes enter the wall. Ideally, you should have an inspection about once a year. We offer r epair, partial rebuild or complete rebuild depending on the state of your chimney.

If you have a gas or wood burning fireplace in need of repair or maintenance, we offer a complete range of repair services that will keep it working at optimum efficiency. How do I get the TEE down my chimney?

Not all installations require a Tee Connector, but if yours does, it doesn't get any easier than this. When a Tee is needed and the masonry chimney has little or no offsets, connect the Tee Body to the bottom of the liner with the attached clamp, the Tee Cap should be attached to the bottom of Tee Body. Before lowering the flex liner and tee body down the chimney, insert the Tee Snout pipe coming off the tee that goes through the wall into the opening in your masonry chimney.

Now lower the flex liner assembly down through chimney, it is recommended to use two people when installing the liner through the chimney.

The Tee Body will need to pass through the clamp that is attached to the Snout, and then tighten the clamp using the attaching screw on the inside of the snout to secure them together. Watch a quick video here. How do I cut my stainless liner? The liner ends will be very sharp so take precaution.

Wear gloves for protection. We have cut these liners with many tools but the quickest, cleanest, and straightest is with an angle grinder with an abrasive wheel. For those who want to use a Hacksaw, Tin Snips, Sawzall, or other device, that is perfectly fine, it may not look pretty when you're finished cutting, but it does get covered up with the Top Plate and Rain Cap, and no one can see it when you finish.

Posted in Chimney Liners. Blog Categories. Recent posts. Why does my fireplace smoke in the house? Also the attention to cleaning up the work area afterwards so you'd never know they were their! I High recommend Bill and the Chimney Company. Bill and his team are nice, friendly and very professional. They did a wonderful job rebuilding my crumbling chimney and replacing bricks at the shoulder section for a very reasonable price.

They were good at matching colour of the new bricks to the original ones, I honestly cannot tell the difference. And they cleaned up nicely after the job had finished. If your chimney needed to be repaired, this is the team you should go to, and you won't regret it. Thumbs up! We had two chimneys done in the spring. Bill and his crew did a wonderful job. They clean after every day.

The installation was quick. They were very professional. I will highly recommend Bill to family and friends. We are very happy with the job. Bill quickly responded to my quote request and he came to check the site. Unfortunately my chimney is not easily accessible as there is no place to put the scaffolding to allow the them to safely work on it. I really appreciate his time and responsiveness for my request.

Requested a quote, Bill got back to me quickly. From the get go he was easy to get along with and offered fair pricing and advice, without any nonsense sales pitches. Bill contacted me a few days before the job was to start. A week or so later Bill contacted again offering to start the job within a day or two. The crew showed up in the morning, they erected scaffolding to do the job properly. They started and finished the job in the same day and cleaned up well.